Features

• Four-channel, half-rack design
• Continuously tunable tracking filters covering 470.100 - 614.375 MHz
• Compatible with D2, DSW, Duet and Digital Hybrid Wireless® transmitters
• Built-in wideband antenna multicoupler with loop-thru for additional receivers
• Antenna bias power enabled from the front panel (fused and over-temperature protected)
• IR bi-directional port for transmitter setup
• Analog and Digital audio outputs with TalkBack (in applicable RX modes)
• Ethernet and USB interface

The DSQD Half Rack Receiver with analog and digital audio outputs utilizes the Lectrosonics signature digital architecture with remarkable audio quality and ultra-low latency. The receiver includes an extended operating range rivaling the best analog and Digital Hybrid Wireless® systems with continuously tunable tracking filters covering 470.100 - 614.375 MHz.

Antenna ports on the rear panel accept input from remote antennas, with a “loop-thru” output to another mainframe using the internal multicoupler. A kit is also available to mount antenna inputs (BNC connectors) on the front panel.

Included Accessories

• 1-USB cable (#21926)
• 1-Bracket, rear tie (#25990) 
• 1-Bracket, front tie (#25991) 
• 1-Rack flange bracket (#27076) 
• 1-Rack “D” handle (#27082) 
• 1-SCR10 cap screw (#28885) 
• 1-Spacer (#28951) 
• 1-Rubber feet, large, stick on (#35664) 
• 1-Hex key (#35800) 
• 1-Hole plug (#35959) 
• 1-right angle BNC antenna, block 20 (#A500RA20) 
• 1-right angle BNC antenna, block 22 (#A500RA22) 
• 1-power supply (#DCR15/4AU) 

Specifications

Operating Spectrum: 470.100 - 614.375 MHz

Frequency Adjustment Range: 25 kHz steps

Sampling Size and Rate: 24-bit, 48 kHz

Digital Modulation: 8PSK with Forward Error Correction

Data Encoding: Proprietary ADPCM Encryption: AES 256-CTR (per FIPS 197 and FIPS 140-2)

System Latency: Digital Output: D2 mode: 0.75 ms plus Dante Duet mode: 1.4 ms plus Dante Hybrid modes: 2.0 ms plus Dante Analog Output: D2 mode: 1.25 ms Duet mode: 1.9 ms Hybrid modes: 2.5 ms Audio Performance:

Frequency Response: 20 Hz - 20 KHz, +\-1 dB THD+N: 0.05% (1 KHz @ -10 dBFS)

Dynamic Range: 108 dB A-wtd, NR=NORMAL

Adjacent Channel Isolation: >85 dB

Diversity Technique: Noiseless antenna switching

Sensitivity: -98 dBm for 10-5 BER

Antenna Inputs/Outputs: Dual BNC female, 50 ohm impedance

Audio Outputs: XLR: Balanced, -35 to +8 dBu

Headphone: 1/4 inch phone jack Dante model only: RJ45 Gigabit Ethernet AES3 model only: TA3M External DC Power: 7 to 18 VDC; 2.5A (max)

Weight: 1.95 lbs.; 880 grams

Dimensions: 8.375 x 1.75 x 7.375 in. 213 x 44.5 x 187 mm.